K2 build up-When to install options.

[Bill_Harris]

Hello K2 Reflectees (??)
When building up a new K2; would it  eliminate some redundent motions while working in a particular area of construction. to install a particular option?  If so, is there a flow chart available?

Carry on

Bill_Harris  

> I'm not sure that's right. Every time I've seen much attenuation, I've not
> been on the right freq. If you look at the height of the peak in
> Spectrogram, it doesn't drop much as you cycle through the widths. A
> primative zero-beat was to go to 100Hz bw, and peak the volume.
>
> Or, a filter center not near the input pitch will attenuate (by design)
> greatly.
>
> Dan / WG4S / K2 #2456
>
> <snip>
> W3FPR - Don Wilhelm
> ... allow better rejection than a narrower filiter and avoid the attenuation
> that occurs with very narrow filters.
> </snip>
>
> _______________________________________________
> Elecraft mailing list
> Post to: [hidden email]
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft   
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft   
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Brian Mury-3]

On Tue, 2004-07-12 at 22:45 +0000, [hidden email] wrote:
> Hello K2 Reflectees (??)
> When building up a new K2; would it  eliminate some redundent motions
> while working in a particular area of construction. to install a
> particular option?  If so, is there a flow chart available?

I would recommend building the basic K2 and getting it working before
adding options. You can, however, add the connectors for the options
while you are building the K2. That will save you some from having to
disassemble/reassemble the K2 later. The K2 manual will walk you through
this near the end of the construction.


--
73, Brian
VE7NGR

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft   
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com