Bill,
You can confirm for yourself by looking at the parts list, but yes go ahead
and solder the SA612 in. NE602, SA602, NE612 and SA612 are all
interchangable and may be considered as the same part.
73,
Don W3FPR
> -----Original Message-----
>
> I finished the control board and it looks good. I didn't like how the
> revised cap and resister went on the back side but otherwise it
> looks good.
> I did have a question. The IC #1 that I received was slightly different
> than specified. It is the only one left so I am assuming it is okay. I
> wanted confirmation before I solder, however. It is called for NE 602 and
> the IC I have is SA 612 C101708 Fn 344B. Is this okay to solder?
>
> Thanks for all the help.
>
> Bill Koucky
>
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.432 / Virus Database: 268.16.0/610 - Release Date: 12/30/2006
2:59 PM
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
