Hi John,
You should be fine. Take your time and enjoy the build.
Finish the one K2 before you start the other. It'll go a whole lot
smoother when you know what to expect.
Also, I'd recommend you consider getting pre-wound toroids from Mike
Morohovich ( 412) 481-2349
[hidden email]. Toroids aren't much
fun, and if the enamel isn't properly removed, any poor connections can
lead to all sorts of grief.
Cheers, Alan
Alan D. Wilcox, W3DVX (K2-5373, K3-40)
570-321-1516
http://WilcoxEngineering.comWilliamsport, PA 17701
John Fritze wrote:
> I started build one of the 2 K2s I ordered at Dayton (one for me and
> the second for Linda K2QYL). After about 5 hours I have the control
> board done. I did the resistence measurments as specified and all are
> OK, except for U6 pins 29 &30, the DIT and DAH pins. The manual
> specifys between 70-90K ohms, I have 95K on both. I'm guessing that
> is OK. Or do I need to look for something fairly minor?
>
> John
> K2QY
> ______________________________________________________________
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
