K2 - first tests and some problems (serial no. 6905)

classic Classic list List threaded Threaded
1 message Options
Reply | Threaded
Open this post in threaded view
|

K2 - first tests and some problems (serial no. 6905)

G4JQT

Hi there. I suspect this may be the first of many questions and requests for advice with my new K2...

First test (K2 manual page 43) revealed that I had stupidly omitted the U2 6V regulator (thought missing from kit until today), so I got the 080 error message.

Added this and did not get the 7100.00c display but 3030 with blinking A and RIT indicators with r above XIT and sometimes a - (dash) above that, depending on band selected.

Scrolling though the bands gives: various 3040/3028/etc frequency readings with a 25023 and "turn 1" and "turn 2" appearing momentarily.

The relays are clicking with band selection and the display seems ok, although I cannot get
ST L 040 but ST L 003  and not INP HAND only INP SCAN

One green bar at extreme right of S-meter.

Shaft encoder rate/direction and battery volts/current display are ok.

Are these related to firing it up first time without 6V U2?

What should I check?

Many thanks.

Ian
     
_________________________________________________________________
http://clk.atdmt.com/UKM/go/197222280/direct/01/
Do you have a story that started on Hotmail? Tell us now
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html