Finally my lasting K2 frequency calibration issue is solved !
Although no errors could be found (all data ok) my K2 has been of frequency
for approx. 1 KHz.
Only thing was the PLL reference frequency. The range was ok (10 KHz) but
just a bit low, 12.095 MHz max. After changing the Xtal and redo the
calibration my readout is now perfect (max PLL freq is now approx. 12.099
MHz, range 10 KHz)
As I didn't found any pointers showing a relation between the actual (max)
PLL frequency and a slightly off dial calibration, it might be good to put
this phenomena to the FAQ/known errors-issues database.
Gl,
Carel, pc5m
p.s. Special thanks to Don w3fpr and Tom n0ss for their help/encouragement
and of course Elecraft for the splendid part replacement service.
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
