K2 front panel board

[Conway Yee]

I am working on the front panel board.  I have a problem with pin 10 of
RP1.  The hole is not completely formed.  There is a small sliver of green
plastic blocking the hole about half way through the board.

Suggestions?

tnx.
Conway Yee, N2JWQ

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Don Wilhelm-4]

Conway,

Although I have not seen it before, it is possible that a bit of the
solder mask material has gotten into that solder hole.  Try sticking a
toothpick or similar tool through the hole.  If that does not clear it,
consult with [hidden email].

73,
Don W3FPR

Conway Yee wrote:

> I am working on the front panel board.  I have a problem with pin 10 of
> RP1.  The hole is not completely formed.  There is a small sliver of green
> plastic blocking the hole about half way through the board.
>
> Suggestions?
>
> tnx.
> Conway Yee, N2JWQ
>  
>

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Conway Yee]

W3FPR writes:
> Try sticking a toothpick or similar tool through the hole.

Worked like a charm.

tnx
Conway Yee, N2JWQ
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html