K2 lost sidetone?
Locked
 
|
Oh man, what timing...2 hours before the start of the contest, and I
went in and did CAL tPA to set the ambient temp of the KPA100, and when I came out of the menus, I had no sidetone anymore! Going through all the menus, all the side tone settings look correct. The rig hears and transmits fine, but the sidetone is silent. I thought I might need to reset back to defaults, but I think that resets all the filters and BFO, etc., right? If that's the case, I've gotta go through realignment again? I'll miss the beginning of the contest :( I'm going to miss it anyhow though at this point. Any ideas short of disassembling and resetting? Thanks, -J _______________________________________________ Elecraft mailing list Post to: [hidden email] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com |
|
|
Jeff,
Your sidetone source likely was switched for some reason or other - maybe by an 'extra' finger press while in the menu Go back into the menu and dial up ST L, press EDIT to move the cursor over to the right side and then tap DISPLAY to toggle the sidetone source. When you hear the sidetone, stop and exit from the menu. In some rare instances, it may take a few 'toggles' to get things to switch properly, so try it several times. If you have a post SN 3000 K2 (or have put the sidetone source change on an older K2 because you added the KPA100 or KIO2) your sidetone source should be 'U8 - 4' - you will see the source displayed briefly each time it is toggled. 73, Don W3FPR > -----Original Message----- > From: [hidden email] > [mailto:[hidden email]]On Behalf Of Jeff Kinzli > Sent: Friday, February 16, 2007 5:06 PM > To: Elecraft Mail Posting > Subject: [Elecraft] K2 lost sidetone? > > > Oh man, what timing...2 hours before the start of the contest, and I > went in and did CAL tPA to set the ambient temp of the KPA100, and > when I came out of the menus, I had no sidetone anymore! > > Going through all the menus, all the side tone settings look correct. > The rig hears and transmits fine, but the sidetone is silent. > > I thought I might need to reset back to defaults, but I think that > resets all the filters and BFO, etc., right? If that's the case, I've > gotta go through realignment again? I'll miss the beginning of the > contest :( I'm going to miss it anyhow though at this point. > > Any ideas short of disassembling and resetting? > > Thanks, > -J > _______________________________________________ > Elecraft mailing list > Post to: [hidden email] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > -- > No virus found in this incoming message. > Checked by AVG Free Edition. > Version: 7.5.441 / Virus Database: 268.18.1/690 - Release Date: > 2/16/2007 2:25 PM > No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.5.441 / Virus Database: 268.18.1/690 - Release Date: 2/16/2007 2:25 PM _______________________________________________ Elecraft mailing list Post to: [hidden email] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com |
|
|
Don, you are exactly correct, thanks again...
-J On 2/16/07, Don Wilhelm <[hidden email]> wrote: > Jeff, > > Your sidetone source likely was switched for some reason or other - maybe by > an 'extra' finger press while in the menu > > Go back into the menu and dial up ST L, press EDIT to move the cursor over > to the right side and then tap DISPLAY to toggle the sidetone source. When > you hear the sidetone, stop and exit from the menu. > > In some rare instances, it may take a few 'toggles' to get things to switch > properly, so try it several times. If you have a post SN 3000 K2 (or have > put the sidetone source change on an older K2 because you added the KPA100 > or KIO2) your sidetone source should be 'U8 - 4' - you will see the source > displayed briefly each time it is toggled. > > 73, > Don W3FPR > > > > > -----Original Message----- > > From: [hidden email] > > [mailto:[hidden email]]On Behalf Of Jeff Kinzli > > Sent: Friday, February 16, 2007 5:06 PM > > To: Elecraft Mail Posting > > Subject: [Elecraft] K2 lost sidetone? > > > > > > Oh man, what timing...2 hours before the start of the contest, and I > > went in and did CAL tPA to set the ambient temp of the KPA100, and > > when I came out of the menus, I had no sidetone anymore! > > > > Going through all the menus, all the side tone settings look correct. > > The rig hears and transmits fine, but the sidetone is silent. > > > > I thought I might need to reset back to defaults, but I think that > > resets all the filters and BFO, etc., right? If that's the case, I've > > gotta go through realignment again? I'll miss the beginning of the > > contest :( I'm going to miss it anyhow though at this point. > > > > Any ideas short of disassembling and resetting? > > > > Thanks, > > -J > > _______________________________________________ > > Elecraft mailing list > > Post to: [hidden email] > > You must be a subscriber to post to the list. > > Subscriber Info (Addr. Change, sub, unsub etc.): > > http://mailman.qth.net/mailman/listinfo/elecraft > > > > Help: http://mailman.qth.net/subscribers.htm > > Elecraft web page: http://www.elecraft.com > > -- > > No virus found in this incoming message. > > Checked by AVG Free Edition. > > Version: 7.5.441 / Virus Database: 268.18.1/690 - Release Date: > > 2/16/2007 2:25 PM > > > -- > No virus found in this outgoing message. > Checked by AVG Free Edition. > Version: 7.5.441 / Virus Database: 268.18.1/690 - Release Date: 2/16/2007 > 2:25 PM > > Elecraft mailing list Post to: [hidden email] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com |
«
Return to Elecraft
|
1 view|%1 views
| Free forum by Nabble | Edit this page |