Klaus,
Are you certain it is actually low audio? Or is it possibly low receive
gain (due to an earlier stage failure). One way to separate the two
possibilities is to observe the S-meter. If there is good S-meter
deflection, then the problem can be found in the product detector and
audio stages, but if the S-meter is not showing a good deflection, the
problem is prior to the product detector.
Nominal values for the receiver RF voltages can be found in Appendix E
of the manual. Connect an oscillator or signal generator to the antenna
and adjust the level as described and follow the steps in Receive Signal
Tracing.
73,
Don W3FPR
Koppendorfer Klaus wrote:
> ich have a k2 with low audio - just when the AF pot is full cw i can listen to signals
> sidetonelevel with 60 is ok,
> AGC voltage at pin 1 U1 ist ok
> the mute q6 and q7 are ok - testet to short source and drain on both - no louder audio
>
> does anyone have reference voltages for product det. and if-amp
> have an tek oscilloskope - so can measure af-hf voltages
>
> tnx
> klaus
> oe6kyg
>
>
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
