Jerry
I've had the K2 and KBT2 since 2001, it works just fine on the shack
bench with a power supply set to 14.2V (as per the KBT2 manual). I keep
the rear panel battery switch turned on, which means the battery is
always charged and ready for use. I haven't run the battery completely
down and have only needed to replaced the battery once. Note gel cells
have a short life expectancy if over discharged.
Since adding the KDSP2, KIO2 and the KSB2, the current consumption isn't
as low as it used to be... I also have a K1 for lower consumption while
away from home, so I haven't used the K2 solely on the internal battery
much recently.
73 Dave, G4AON
K2 #1892
--------------
Hey gang:
Just a quick question. I've been reading the K2 manuals and have
some minor confusion about the operation of the K2 using a power supply.
Can I operate the rig via a power supply with the internal
battery switch turned on???
Just want to be sure I'm not going to hurt something. :-)
Manuals say I can charge the internal battery from a power supply with the
battery switch in either position.
Just curious if I need to use caution while operating.
Thanks and 72:
Jerry N0JRN
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
