Scott,
Interchanging the AUX RF and the DC cnnectors would not harm the K2 base
because the AUX RF connector has a protective series capacitor.
What is likely to happen is that you vaporized the trace for the 12VDC
in the KPA100 leading to the red wire of the KPA100 12 volt output to
the base K2 (that red wire would have been connected to ground when it
was plugged into the AUX RF header).
Remove all power from the KPA100 and check continuity from the red side
of the APP connector to the junction of the red wire soldered to the
KPA100 board - if you are fortunate, you will have continuity there (if
not, find the burned KPA100 PC trace and repair it with wire).
If you have continuity to the junction of the red wire and the KPA100
board, then the red wire or the connector crimp pin is the problem -
replace the wire and crimp pin and you should be back in business.
73,
Don W3FPR
[hidden email] wrote:
> Hello
> I had to replace diodes d16 and d17 on my K2 100 watt amp.
> When putting it back together I was distracted, and reversed
> the leads on P6 aux rf and P3 aux 12 volt leads.
> I've been told that bad things happen when you do that. So the
> rig will not power up with the amp installed. but with it
> unstalled the K2 seems to work ok. What do you suppose I
> destroyed? I'm going to refrain from ever opening the case
> on any radio.
> Thanks
> Scott N5SM
>
>
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
