Anthony,
I suspect you have the 'new' knob. The one I am referring to is the
same one used on the KX3 and has a rubber ring.
The knob previously used on the K2 has become unavailable.
If so, contact support and request 2 additional felt washers and stack them.
I have not yet had a chance to check out a K2 with the new encoder and
that new knob.
73,
Don W3FPR
On 5/27/2017 2:17 PM, Anthony Clare wrote:
> Hello:
>
> I am well into the assembly of K2 #7734 and ran into a snag. The vfo knob will
> not come close enough to the felt washer to create any friction. I cannot see
> where I would have done anything wrong during assembly.
>
> Otherwise, the new encoder feels really good. I just need to stop the
> freewheeling of the knob when I let go of it. I have some ideas in my head,
> but I wanted to see what you guys have done first.
>
> Any ideas?
>
> Anthony
> n3kcb
>
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html> Message delivered to
[hidden email]
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
