|
|
At the W4AAW remote operation, several K3/0 or Mini users are constantly getting "Radio Reset" messages from their local N1MM+ instance, which indicates that the N1MM polling of the K3/Mini (to obtain freq/mode data) has not received a response for 15 seconds or more.
I noticed in the K3 firmware release notes (below) that a "noise fix" for the Mini suspends RemoteRig polling during PTT.
Any details on that? If VOX is in use for CW, is the PTT condition mean key down or during the entire time VOX is active? Ie, would QSK mode result in less polling disruption than VOX on CW?
What I'm looking for is some way to reduce any disruption across the RRC link that would impact N1MM polling.
73 John K3TN
MCU 4.93 / DSP 2.83, 10-16-2014
* PSK63 MODE ADDED: To select PSK31 or PSK63, first tap either end of the MODE switch to select DATA, then hold the DATA MD switch and use VFO A to select the PSK data rate.
* KAT500 POWER-ON REMINDER ON K3 DISPLAY: If a powered-off KAT500 is pulling the auxBus signal low when the K3 is first turned on, "TURN ON KAT500" is displayed. Previously this condition would lock up the K3 without explanation.
* K3/0-MINI TX NOISE REDUCTION: Polling by Remote-Rig units is suspended during PTT use to reduce a "ticking" noise heard in some cases.
* Changes to synthesizer, KXV3, and KPA3 device drivers (no effect on normal operation).
|
Locked
