K3/0-mini disassembly

[Scott Townley]

I have a K3/0-mini that I removed the rear bail from.  Basically I
unscrewed the four screws, cracked open the case just a bit, and shook
all the internal hardware (nuts/washers) out, and buttoned it back up.
Now I want to put the bail back on.  I've gotten the case fully opened
up (two halves), but I'm having a challenge with the PCB that's attached
to the rear half.  It appears those four black "nubs" that you can see
on the back are some sort of nylon standoff that's being used for
stiffening the PCB.  But it's not obvious to me how to remove them or
otherwise disengage them.  Of course I'd prefer to do this without
destroying them and leaving four holes in the back.
Any suggestions?
TIA,
Scott NX7U

--
Scott NX7U

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]

[Nr4c]

If there is an Assembly Manual look into it for assistance. If not, maybe some help in the operators manual?.

Sent from my iPhone
...nr4c. bill

> On Jan 19, 2019, at 10:05 AM, Scott Townley <[hidden email]> wrote:
>
> I have a K3/0-mini that I removed the rear bail from.  Basically I unscrewed the four screws, cracked open the case just a bit, and shook all the internal hardware (nuts/washers) out, and buttoned it back up.
> Now I want to put the bail back on.  I've gotten the case fully opened up (two halves), but I'm having a challenge with the PCB that's attached to the rear half.  It appears those four black "nubs" that you can see on the back are some sort of nylon standoff that's being used for stiffening the PCB.  But it's not obvious to me how to remove them or otherwise disengage them.  Of course I'd prefer to do this without destroying them and leaving four holes in the back.
> Any suggestions?
> TIA,
> Scott NX7U
>
> --
> Scott NX7U
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[hidden email]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to [hidden email]

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]