That is the correct procedure.
If it happens again, your tx gain calibration may be getting messed up.
Do not "TUNE" at exactly 5 or 50 watts into other than a flat SWR as
that will reset the calibration.
See TXGN in the manual under config menu items.
Keith
On 3/5/2012 5:35 AM, Adriano Perazio wrote:
> It was discussed few days ago about a problem of low power output on the k3 sometimes – bu i don´t remember the solution.
> Well i had noticed that issue during day by day operation and solved after a turn on-off-on.
> But this weekend during the ARRL, it happened many times. The radio went to 5w only or so.
> Only once i saw an error on the lcd: ERR TXG.
> I found a “solution”: on the k3 utility: re-calibrate the radio w/ a dummy load.
> Anyone could help on that?
>
> Tnx
>
> PY2ADR / PR2X
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
