Jack,
That isn't quite what I meant. You need to set CONFIG:DUAL PB to APF.
Now select preset I, and turn APF ON by holding the DUAL PB switch.
Then switch to preset II and turn APF off again using the DUAL PB
switch. From then on you should be able to alternate between I and II
and have APF turn on and off.
You can also vary WIDTH for each preset. For example, for preset I, I
set WIDTH to 200 Hz and APF on. For preset II I set WIDTH to 400 Hz
with APF off.
73,
Wayne
N6KR
On Feb 11, 2011, at 9:47 AM, Jack Regan wrote:
> I have tried to use Wayne's suggestion for setting APF on for one
> preset and
> of for the other. No luck. If I set DUAL PB to APF using CONFIG when
> PRESET
> I is active and then set DUAL PB to nor when preset II is active
> when I
> switch back to preset I then DUAL PB has also been changed nor. I have
> checked the latest manual. I have the latest firmware.
>
> What am I missing? Help!
>
>
>
> Jack, AE6GC
>
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
