K3 - ATU/Bypass Ant1/Ant2

[dave.wilburn]

I have recently had the need to use the internal antenna tuner on one
antenna and to bypass it on the other antenna.  I haven't been able to
find a way to do this.  I am on the latest beta firmware.  I was under
the impression that something had been changed in this matter.
--

David Wilburn
NM4M
http://www.nm4m.com


_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Julian, G4ILO]

David Wilburn wrote

I have recently had the need to use the internal antenna tuner on one
antenna and to bypass it on the other antenna.  I haven't been able to
find a way to do this.  I am on the latest beta firmware.  I was under
the impression that something had been changed in this matter.

No, I'm afraid not. The only way to avoid having to go into the menu to switch in/out the ATU is to tune it up into a 50 ohm load on that output and then avoid pressing the ATU TUNE button on that band. Easier said than done in my case...