K3: All-mode squelch suggestions

[KM5Q]

Based on FW 3.04, here's what I would like to see, so I'll toss it  
around:

I would like a timed decay, so when the sound goes off, it doesn't do  
it abruptly, but with a timed decay. This will make listening more  
pleasant, less choppy.

I'd also like ability to CONFIG a squelched volume to something more  
than zero, so it would still be slightly audible.

In SSB mode, adjusting the SQL shows the setting numerically on the  
VFO B screen. In CW mode, it does not. I'm not sure I care, but I  
don't see why it shouldn't be consistent between those modes. There  
could be a CONFIG to choose whether to see it on the screen or not.

Good work!
Windy KM5Q
K3 #764


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Bob Cunnings NW8L]

Using firmware 3.06 here and adjusting SQL does show the setting
numerically in the VFO B area in CW mode. I don't think 3.04 supported
SQL in CW mode at all, did it?

Bob NW8L

On Sat, Apr 4, 2009 at 9:30 AM, KM5Q <[hidden email]> wrote:
> In SSB mode, adjusting the SQL shows the setting numerically on the
> VFO B screen. In CW mode, it does not. I'm not sure I care, but I
> don't see why it shouldn't be consistent between those modes. There
> could be a CONFIG to choose whether to see it on the screen or not.
>
> Good work!
> Windy KM5Q
> K3 #764
>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html