I do not think anyone opting to make the short procedure has
anything to worry about regarding putting pressure on the PC board when mounting
the RFC 47. This choke is mounted between the thru-hole on the 12V trace
and the pigtail through the solder pad for the original RFC on top of
the board. Again, if your K3 has the KRX3 installed, it is best to use the
short procedure to avoid a possible problem with ESD. Previously, I
had an occasion to remove my KRX3 to reposition my TMP cables so they would
not be squeezed between the top of the filters and the bottom of the KRX3
case. I used a properly grounded wrist strap and work surface and
still encountered an apparent ESD problem. Roy Morris
W4WFB
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
