K3 CW Contest Settings

[Rich-4]

As a new K3 owner I would be interested in the settings folks use for CW
contesting.

 

The SS was my first contest with the K3 and I did well for the time spent
and the fact that I only have vertical antennas, but I am not sure I
maximized the filters/DSP.

 

You can email me direct to keep the clutter off of the reflector.

 

Thank you advance.

 

Rich

K3RWN

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[alorona]

Hi, Rich, I will risk cluttering the reflector with a response.

A good contest rig becomes totally transparent during the contest. The Ten Tec Omni VI was such a rig. I think that the K3 will become like that once I get more familiar with it. I am a less-than-two-month owner and like you, the CW SS was my first contest with the K3.

By "transparent" I mean, can one operate the entire contest using only the VFO knob? It is possible and when it happens you know you are concentrating on the contest rather than wasting brain power on the rig.

There were glimpses of transparency, though. Before the contest I got fancy and had set up N1MM to be able to switch between 1500 and 400 Hz bandwidths but after a few minutes I just left it at 400 and never touched it again. Similarly, this morning I had occasion to turn on NR, then forgot that it was on and it stayed on for the remainder of the contest. That's a rig that wants to become invisible. The same thing happened to me two years ago with a K2 on the 160m contest. There's a trend developing here. :^)

I need to become second nature with the IF shift; I should have used it more but am so used to traditional IF shift that I'm still not comfortable with it. It doesn't shrink the bandwidth like IF Shifts on older rigs, and I need more time to assimilate that. I think I will set up two macros in time for the Phone SS that will 1/ shift down and shrink bandwidth, or 2/ shift up and shrink, like I have on my K2.

I never used much of anything else. Never used RIT, NB, WIDTH, MON, RF GAIN, SUB, or my macros. I did use SPLIT once when VO1MP was listening up 1, the first time in 30 years of Sweepstakeses.

The K3 is the easiest rig I've ever had to set up for remote operation. I use N1MM. The CW keying was flawless and everything else worked pretty well. Maybe I just got lucky setting everything up?

Sorry for the long answer, Rich. To make a long answer longer, here are my "Toyota Corolla" settings on 20m: no ATT or PRE, BW=400, QSK on, NR 5-3, RF GAIN full on, SPOT=550 Hz, and RATE=10 Hz. Everything else was off.


 


----- Original Message ----
From: K3RWN <[hidden email]>
To: [hidden email]
Sent: Sun, November 8, 2009 7:53:27 PM
Subject: [Elecraft] K3 CW Contest Settings

As a new K3 owner I would be interested in the settings folks use for CW contesting.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Julius Fazekas n2wn]

For 160/80/40, I have the ATT on, unless using a Rx antenna. Assuming you have that capability, then settings would depend on the antenna.

I do vary my BW depending on whether I'm running or not. If running and the band gets crowded, I crank down my BW.

I do use RIT/XIT, particularly in DX contests. I did need RIT a couple times when folks called way off freq to make the exchange go smoother.

I'm loaded for bear on CW and RTTY with a wide range of roofing filters. May be overkill, would like to see a 700 or 750 Hz filter in the line up. Op preference ;o)

Ride the AF or RF gain and spin the VFO and away we go.

73,
Julius
n2wn

Al Lorona wrote

Hi, Rich, I will risk cluttering the reflector with a response.

A good contest rig becomes totally transparent during the contest. The Ten Tec Omni VI was such a rig. I think that the K3 will become like that once I get more familiar with it. I am a less-than-two-month owner and like you, the CW SS was my first contest with the K3.

By "transparent" I mean, can one operate the entire contest using only the VFO knob? It is possible and when it happens you know you are concentrating on the contest rather than wasting brain power on the rig.

There were glimpses of transparency, though. Before the contest I got fancy and had set up N1MM to be able to switch between 1500 and 400 Hz bandwidths but after a few minutes I just left it at 400 and never touched it again. Similarly, this morning I had occasion to turn on NR, then forgot that it was on and it stayed on for the remainder of the contest. That's a rig that wants to become invisible. The same thing happened to me two years ago with a K2 on the 160m contest. There's a trend developing here. :^)

I need to become second nature with the IF shift; I should have used it more but am so used to traditional IF shift that I'm still not comfortable with it. It doesn't shrink the bandwidth like IF Shifts on older rigs, and I need more time to assimilate that. I think I will set up two macros in time for the Phone SS that will 1/ shift down and shrink bandwidth, or 2/ shift up and shrink, like I have on my K2.

I never used much of anything else. Never used RIT, NB, WIDTH, MON, RF GAIN, SUB, or my macros. I did use SPLIT once when VO1MP was listening up 1, the first time in 30 years of Sweepstakeses.

The K3 is the easiest rig I've ever had to set up for remote operation. I use N1MM. The CW keying was flawless and everything else worked pretty well. Maybe I just got lucky setting everything up?

Sorry for the long answer, Rich. To make a long answer longer, here are my "Toyota Corolla" settings on 20m: no ATT or PRE, BW=400, QSK on, NR 5-3, RF GAIN full on, SPOT=550 Hz, and RATE=10 Hz. Everything else was off.


 


----- Original Message ----
From: K3RWN <[e-mail]>
To: [e-mail]
Sent: Sun, November 8, 2009 7:53:27 PM
Subject: [Elecraft] K3 CW Contest Settings

As a new K3 owner I would be interested in the settings folks use for CW contesting.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[e-mail]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html