This happened to me not on a K3 but in a headphone conector on a mixing
board. but the same connectors. when the tip came off the
connector the tip was attached to a pin that extended trough the ring
a sleve. so what was left inside the mixer was not so deep down the
hole. with a flashlight and very fine long needle nose pliers I was
able to grab it and pull it out. no damage done.
David Moes
President: Peterborough Amateur Radio Club.
[hidden email]
VE3DVY, VE3SD
On 11/17/2014 16:56, Oli, DL1OLI wrote:
> Hello,
> a friend of mine, also a Ham, bought his new K3 some weeks ago. He is still leaning all the functions, but has a Problem.
>
> He lost the tip of then 1/4" connector of his More-key in the K3 rear connector, After removing of the 1/4" (6.3mm) plug from his K3 he noticed that the tip is missing and still in the Connector in the K3.
>
> Has anyone a good idea, how to remove this without destroying the connector?
>
> vy 73
> Oli
> DL1OLI/AJ4UR
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html> Message delivered to
[hidden email]
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
