Glenn
You turn off the unused filters, don't forget to set the offset for the
2K7 and 200 Hz filters (zero for 8 pole units). Assign the 2K7 for TX.
I used my own GPS derived frequency standard to set my K3 (very easy as
it outputs 10 MHz and harmonics). Any of the 40m broadcast stations
would be fine, they are going to be within 1 or 2 Hz.
73 Dave, G4AON
K3/100 #80
-------------
I just finished building my K3 and I'm now ready to start the Test and
Calibration Phase (starting at page 57 in the assembly manual). At this
time
I have 2 questions.
1) I have installed a 2k7 filter in FL3 and a 200Hz filter in FL5. The
other
slots are empty. I assume I have to set the filter width of the unused
slots
to 0 with 0 offset and assign FL3 to transmitting duties in the TX FL menu?
2) The Reference Oscillator Calibration section says to zerobeat a strong
local AM broadcast signal. What have the EU K3 builders used as a reference?
Thanks very much for taking the time to answer
73
Glenn ON4WIX
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
