[K3] DSP board rev level

[Mike Reublin]

Is it possible to determine the rev code of the DSP board without removing it?

73, Mike NF4L
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Don Wilhelm-4]

You only have to remove the front panel *assembly* to be able to see the
label..  It cannot be seen with the K3 fully assembled.

73,
Don W3FPR

On 7/5/2013 8:34 AM, Mike Reublin wrote:

> Is it possible to determine the rev code of the DSP board without removing it?
>
> 73, Mike NF4L
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[hidden email]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html