[K3] Data Mode AFSK A Dual PB

[W4JBB]

I am having some trouble - probably cockpit error.

I have not really been working any of the W1AW/x stations on digital
modes until the past couple of days. Upon reading Fred Cady's book and
the K3 manual, I find that in AFSK A, I should be able to set the DUAL
PB. I cannot. I get an "N/A" message.

I *am* in data mode and I am in AFSK A.

I have the standard 2.7 kHz filter and a 500 Hz filter. They are both
enabled on the Main and Sub receivers for DATA.

I have even disconnected from RUMlog and cocoaModem just in case they
were causing an issue.

I just reset the K3 and still have the same issue.

I just checked on my KX3 and noticed that DATA A, AFSK A, and FSK D look
different on the filter display. On the KX3, AFSK A and FSK D look the
same (DTF - similar to what is on page 32 of the K3 manual).

On my K3, AFSK A and DATA A look the same (no DTF for AFSK A). Have I
turned a knob or made a setting that has done this? I have to admit,
until recently, I have only used DATA A with Fldigi, but I have found
the integration with RUMlog and cocoaModem to be nice. I'm not really
used to AFSK A.

Any other tips?

Thanks,
Joel - W4JBB


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html