I was setting up some band edge memories (KM5Q's post of 5/10). I goofed and hit M>V instead of V>M. Then selected an 'empty' memory position, the main freq display was "- - - -". I hit M>V again. The VFO jumps to 49.9940 mHz and displays ERR PL 1
Seems like the M>V routine should test for a valid frequency.
Manual frequency entry or selecting a properly setup memory brings the K3 back all OK.
I couldn't find reference to this - sorry if it's a dupe.
Using the beta firmware 1.96
73, Bill N2BC
K3/929
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
