K3 :: "ERR PL2" message

[inventor61 .]

Today I installed my KRX3 (Christmas present) and some other accessories.

I get the "ERR PL2" message on the screen when I power up, or, when I
enable the 2nd receiver.

So, I changed R10 on both of the SYN boards to a 56k part, as the app
note showed that could possibly fix the problem.
For me, it did not.  "ERR PL2" still appears.

I am running 2.76/1.98 FW.  The radio seems to work fine, other than
this odd behavior.

Any ideas?


Steve KZ1X/4
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Iain MacDonnell - N6ML]

inventor_sixty_one wrote:

> Today I installed my KRX3 (Christmas present) and some other accessories.
>
> I get the "ERR PL2" message on the screen when I power up, or, when I
> enable the 2nd receiver.
>
> So, I changed R10 on both of the SYN boards to a 56k part, as the app
> note showed that could possibly fix the problem.
> For me, it did not.  "ERR PL2" still appears.
>
> I am running 2.76/1.98 FW.  The radio seems to work fine, other than
> this odd behavior.
>
> Any ideas?

Did you do the synth calibration? I think I was getting "ERR PL2" until
I actually followed the instructions and did that :)

     ~Iain / N6ML


_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com