K3 ERR TXG Message

[Mike KS7D]

I get an ERR TXG message after running the high power TX gain procedure on 12, 15, and 17 meter bands. However, both the K3 and my wattmeter show 50 watts output in each case. This error message does not show up on any of the other bands, and it does not show up when operating on any of the bands.

Any thoughts from list members on what the problem might be? Thanks.

Mike, ks7d
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Bill W4ZV]

Mike Downs-2 wrote

I get an ERR TXG message after running the high power TX gain procedure on 12, 15, and 17 meter bands. However, both the K3 and my wattmeter show 50 watts output in each case. This error message does not show up on any of the other bands, and it does not show up when operating on any of the bands.

Any thoughts from list members on what the problem might be? Thanks.

Mike, ks7d

You might try setting the VFO to a mid-band frequency on each of those bands before doing the procedure.

73,  Bill