Bill,
Do you have the correct filter set for SSB transmit? - it sounds like
you do not. ERR TxF means transmit filter error! The 2.7/2.8 kHz
filter must be selected for SSB and CW transmit. See the menu entries
on page 51 "FLTX". If you placed your 2.7/2.8 filter anywhere other
than the FL1 position, this menu entry must be changed from the default
position of FL1.
73,
Don W3FPR
KXB wrote:
> Well...I've twisted something out of sequence. (was in the config menu before this happened) I get "ERR TxF"... SSB phone, any band, dummy load. Locks out the xmtr after the first key-up . I don't see it in the manual In the Error Msg. list. (page 58)
> Any suggestions will be greatly appreciated.
>
> BillHarris
>
>
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
