K3: FW 5.26 an TUN PWR problem K3/100 #727

[alexandr.kobranov]

Hi,
just shortly testet FW 5.26 on my old K3/100 #727 and having problem
with TUN PWR - when set to 10W there is no power (or 1 - 2W) after TUN
activated (holding button) and then no SWR indication, COMP/ALC disp
blinking. Tried 14W and also the same. (to avoid differencies in the
10W/100W PA mode).
When I tried to move PWR level by knob then it was jumping to correct
level and next try was ok.
I made a PWR calibration (5W and 50W) and it was the same.

Step back to 5.14 was solution and again it is working OK.

Any similar experience? I was not able to test for longer time and check
all possible dependencies :-(

73!
Lexa, ok1dst

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]