K3 Filter Settings

[K0YR]

I have 2 K-3's in SO2R configuration with a basic 2.7 Khz and 400 hz
filters.
When listening to RTTY and the filter is wide open there will be a lot of
signals.
Turning the filter to 400 Hz the signals seem to just about disappear with
only the very strong ones audible/visible. Where am I a miss in my setup???
Tom
--
K0YR
C/O Thomas Rieff
2059 Sundance Lane
North Mankato, MN 56001

[phone] Cell
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Iain MacDonnell - N6ML-2]

On Fri, Aug 10, 2012 at 3:20 PM, Thomas Rieff <[hidden email]> wrote:
> I have 2 K-3's in SO2R configuration with a basic 2.7 Khz and 400 hz
> filters.
> When listening to RTTY and the filter is wide open there will be a lot of
> signals.
> Turning the filter to 400 Hz the signals seem to just about disappear with
> only the very strong ones audible/visible. Where am I a miss in my setup???

Disappear where?

I suspect you're using software that's configured with a different
mark frequency than the K3 (use the PITCH) control in AFSK A or FSK D
data sub-modes.

73,

    ~iain / N6ML
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html