Also, remember to turn the K3 power off and then on after loading
firmware.
Fred Cady
fcady at ieee dot org
> -----Original Message-----
> From:
[hidden email]
> [mailto:
[hidden email]] On Behalf Of K5WA
> Sent: Saturday, February 05, 2011 7:56 AM
> To: 'Elecraft reflector'
> Subject: [Elecraft] K3 Firmware Reload Reminder
>
> I know this gets mentioned regularly but it sure worked for
> me today. I got
> a very strange behavior after loading FW 4.25. My S meter
> would jump to
> full scale whenever I reduced the bandwidth below 500 Hz and
> the RX would go
> dead. After a lot of head scratching and unplugging of
> cables to eliminate
> issues, I reloaded 4.25 and everything just worked perfectly
> again. I guess
> the bits and bytes get crossways occasionally and a nice reload puts
> everything back in order. I hope you think of this faster
> than I did if you
> ever need a bit of help.
>
> 73,
> Bob K5WA
>
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html