Just purchased the keyer. Configured the jumper setting inside the
keyer for a kenwood configuration since I read that it would work for
the K3 and MFJ doesn't give you any configuration for the HM-10. The
keyer works but I can only use the internal mike to record a message.
Anyone configure this setup?
Also, I had a lot of noise (like wind blowing hard) coming out of my
speaker on the K3 when I played back the recorded message. The only way
to stop this annoyance was to disconnect the ground wire I had attached
on the GND lug on the back of the keyer. Any thoughts on either of
these 2 issues?
Tnx Jerry K9PY
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
