K3 KRX3 - BNC or KAT3?

[Vic K2VCO]

David Ferrington, M0XDF wrote:
> Thanks David - helps if you RTFM. You haven't found any problems with
> the TMP lead from the KAT3 then? I wondered if there might be some stray
> RF pickup.

I used the BNC, so I simply disconnected the KAT3 cable from both ends
and coiled it up. I placed a bent solder lug under one of the
thumbscrews on top of the KRX3 and used it to hold the cable in place in
case I wanted it in the future.
--
73,
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Ken Wagner K3IU]

I just tucked them out of the way.

David Ferrington, M0XDF wrote:
> Ok, so what did you do with the unattached connections? Did you sleeve
> them, did you tuck them out of the way somewhere?
> --
>
> On 14 Aug 2008, at 11:36, Ken K3IU wrote:
>> When I installed the KRX3, I physically installed both the BNC
>> connector and the KAT3 cables but did not connect either to the KRX3.
>> Maybe later..
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com