Got it now! Thanks to all who
responded directly and so quickly. Finally got through this think skull of
mine!
73 de Terry, WØFM
_______________________
I am completing the
installation of my KRX3. I am electing to share the selected antenna
(ANT-1 or ANT-2) with the sub receiver. I have the KAT3 installed.
Do I still need to connect the 12” TMP cable between the KRX3 and J92 on the
KAT3, or is this connection made somewhere else in the circuitry?
On page 37 of my KRX3 installation manual (Rev. A) it states
“If installed, attach the antenna cable connected to either the KAT3 or to the
AUX RF BNC jack on the rear panel to J92 at the end of the KRX3 as
shown”. I DO have the KAT3 installed, but am confused if this cable is
REQUIRED for the sub receiver to work at all, or if this step is referencing
the option to “Installing the Auxiliary KRX3 Antenna Input Via the KAT3” which
I have elected to pass on.
I don’t see any other way of the signal getting from the ANT
connection on the back of the rig to the sub receiver, but, then again, there
are a number of multi-pin connections on the sub receiver.
Please respond direct as I am in digest mode and would like
to wrap this up this afternoon if possible. My call AT swbell DOT net.
Many thanks.
73,
Terry, WØFM
K3/100 #474
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
