Hi Barry,
Do make sure that BOTH connectors between the Front Panel and DSP
boards are mated. If you have the connector with the single row of
pins out of it's socket then the Front Panel mic socket will not
work.
So far, I have managed to achieve this TWICE !
73
Stewart G3RXQ
On Thu, 22 Jan 2009 09:46:19 -0000, Barry Simpson wrote:
> I have just completed the installation of a KRX3 into my K3. I
found the installation process difficult but after a minor hiccup
with the synthesiser calibration I had to reload the firmware
it is working fine and appears to perform exactly the same as the
main receiver.
>
>
>
> However the bad news is that the front panel microphone socket
is no longer operative although the rear microphone connector
works fine. And yes I have tried the various menu settings but to
no avail.
>
>
>
> It would seem that all the plugging and unplugging has disturbed
or broken one of the microphone socket connections. Before I start
delving into the rig again has anyone any suggestion where the
problem might lie. I seem to recall someone else having a similar
problem after installing the KRX3.
>
>
>
> Any input would be appreciated.
>
>
>
> Barry Simpson VK2BJ
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
