Mike,
It sounds like you have done everything recommended in the
Troubleshooting part of the manual to isolate the problem.
Next step is to email customer support
[hidden email] to see if
they can offer any additional information. They can give you
information on the meaning of the extended error codes.
73,
Don W3FPR
On 10/12/2014 2:12 AM, Michael Eberle wrote:
>
> When the sub receiver is activated on any band 20 - 10 Meters, I
> started getting ERR PL2 messages. I opened the radio up and checked
> all the cables and did not see anything obviously wrong. When I tried
> the synthesizer calibration, I get error messages ERR PL2 E00130 and
> ERR VC4 00039. I pulled the KSYN3 boards and swapped them and the
> problem followed it to the main receiver and the sub is fine. Is
> there anything that can be done short of ordering a new KSYN3 module?
>
> Thanks,
> Mike - KI0HA
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
