I finally started building my kit and have run across a small issue.
I am to the stage where I need to install the KXV3 transverter board. The
pictures show two bushings that appear to be soldered onto the board so that
you can tighten down the board to the rear panel. The bushings appear to
provide about a 1/2 inch of separation between the rear panel and the KXV3
board. My board does not have these two bushings. Has this been eliminated
from the build?
The kit was sent to me around the end of April.
Everything else has gone together great.
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
