Hi,
I'm not quite sure if the following a bug under 3.30: Mode is set to Data FSK D When sending text to the TRX using the KY command, the text will be sent out and after that the signal is idling (didles) a while before the K3 switchs to RX. That's okay. But when sending the next KY command during this idling time, the transmission changes to an unmodulated carrier, without didles. It takes few seconds before the next text will be send out. Any suggestions? 73 de Tom, DL2RUM |
Interesting. I can reproduce this using KComm by selecting the K3 DSP modems option, clicking Start sending and typing slowly. PSK D appears to have the same problem. The transmission doesn't change to a single tone, but there is a delay of a couple of seconds before the next character is sent. This is with the last beta version sent to registered beta testers.
Julian, G4ILO. K2 #392 K3 #222 KX3 #110
* G4ILO's Shack - http://www.g4ilo.com * KComm - http://www.g4ilo.com/kcomm.html * KTune - http://www.g4ilo.com/ktune.html |
I could send only one command for the text to send, but then there is no way to interrupt the transmission. It seems the ˆD don't clear the buffer and stops sending immediately.
In this way the KY command is useless for me in RTTY. My idea was to add direct FSK output in my Dx-ped logger. 73 de Tom, DL2RUM
|
You are right about this, too. I am sure it did used to work when I originally wrote the code for KComm to work with it. But I haven't used it much since I always have soundcard software anyway, so I don't know when it stopped working.
Julian, G4ILO. K2 #392 K3 #222 KX3 #110
* G4ILO's Shack - http://www.g4ilo.com * KComm - http://www.g4ilo.com/kcomm.html * KTune - http://www.g4ilo.com/ktune.html |
Administrator
|
I'll look into this on the K3 end.
73, Wayne N6KR On Sep 29, 2009, at 9:30 AM, Julian, G4ILO wrote: > > > > Tom, DL2RUM wrote: >> >> I could send only one command for the text to send, but then there >> is no >> way to interrupt the transmission. It seems the ˆD don't clear the >> buffer >> and stops sending immediately. >> In this way the KY command is useless for me in RTTY. My idea was >> to add >> direct FSK output in my Dx-ped logger. >> >> 73 de Tom, DL2RUM >> >> > You are right about this, too. I am sure it did used to work when I > originally wrote the code for KComm to work with it. But I haven't > used it > much since I always have soundcard software anyway, so I don't know > when it > stopped working. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[hidden email] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html |
The problem still exists under 3.63 73 de Tom, DL2RUM |
Free forum by Nabble | Edit this page |