K3 Keyer Cable Connection Problem

classic Classic list List threaded Threaded
2 messages Options
Reply | Threaded
Open this post in threaded view
|

K3 Keyer Cable Connection Problem

W5KXX
I have been unable to get my new BY-4 paddle keyer to work with my new K3. The BY-4 is connected to the K3 using the Bencher Universal Hook-up kit cable as follows:

Black:  ground
White: right paddle
Red: left paddle

The K3 seems to be configured correctly. Tone volume level and keyer speed have been set. The unit is in Test mode, per directions in the owner's manual.

The Bencher factory cable comes wired to a 1/8" plug. The kit includes a 1/4" adapter. When sliding the 1/4" plug into the Paddle jack of the K3 I noticed that I first hear a series of continuous dashes, then  continuous dots and alternating dashes, and then nothing after the plug is fully seated into the jack. When the paddles are touched afterward nothing is triggered.

Is something wrong with the Bencher cable plug or its adapter? Perhaps the way the plug (or adapter) is factory wired it does not work with all transceivers. If so, what should I buy to replace the cable and plug? How should it be wired?

Thank you for your help.

Mark
W5KXX
Reply | Threaded
Open this post in threaded view
|

Re: K3 Keyer Cable Connection Problem

AD9DX
If you are gettin the continuous "dots" and "dashes" I would think the problem is not in the K3 but in the cable or paddles. Do you have the VOX on in CW mode?