K3 LPA bottom cover

[C L Jonkers]

I recently purchased a used K3, # 4601, and it  operates just fine. However, in
going through the transceiver, the rear bottom panel of this K3 does not seat
flush but rides high on the RF board's standoffs causing the cover to bow,  and
may be flexing the RF board as well.  Any ideas?
73
Neil NJ6L
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[ke9uw]

Are the standoffs 1/4 inch in length as specified?

Sent from my iPad

On Apr 11, 2012, at 2:04 PM, "C L Jonkers" <[hidden email]> wrote:

> I recently purchased a used K3, # 4601, and it  operates just fine. However, in
> going through the transceiver, the rear bottom panel of this K3 does not seat
> flush but rides high on the RF board's standoffs causing the cover to bow,  and
> may be flexing the RF board as well.  Any ideas?
> 73
> Neil NJ6L
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[hidden email]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html