K3 LPA failure, again

classic Classic list List threaded Threaded
2 messages Options
Reply | Threaded
Open this post in threaded view
|

K3 LPA failure, again

Martin Sole-3
Hi,

So I had some success in fixing this and thought I would write it up
here briefly for future reference.

Short version
C6 on the K3REF module had become a 12 ohm resistor.

Longer version
Finding the 7T line only going to 3.5 volts or so was suspicious.
Measuring the resistance to ground of that line showed about 20 ohms
where the 7 volts is generated at U11 on the RF board, very suspicious.
The first step then was to remove any removable item that has a
connection to the 7T line. That's most modules in the K3. Checking the
resistance of the 7T line each time I removed a plug in module showed
the fault to be somewhere on the K3REF module. The 7T line on this board
goes to Q3 via R16, R8 and R9 and also to Q2 and U3 via L5. Measuring
either side of L5 showed  lower resistance on the Q2 and U3 side, now
around 12 ohms as opposed to 14 or so at pin 3 of P75. Focus then was
directed at Q2 and U3 as likely culprits being active devices likely
more prone to failure but removing Q2 showed no change nor did very
carefully lifting pin8 of U3 and confirming no connection to L5. That
left C6 as the remaining component on that line and its removal restored
a much healthier 2.7k resistance to ground on that line as formed by
R16, R8 and R9 around Q3 noted above.

I don't have any of the microscopic 0.1uF capacitors used in this
location, are they 0402? but I have a good selection of 1206 parts and
being smaller than the chokes on this board I considered it a suitable
change. The board mounts very close to the chassis so size is critical.

All restored and the rig is back to normal working order. I don't know
if these capacitors are prone generally to such failures but at least it
was on a plug in board so easy to narrow down.

So that was a fun Saturday afternoon for an hour or so, hopefully the
radio will keep on working well now.

Martin, HS0ZED

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]
Reply | Threaded
Open this post in threaded view
|

Re: K3 LPA failure, again

KeithWE6R
Administrator
Hi all;
Very good troubleshooting Martin.
That is not a common failure and those BYPASS caps are used everywhere.
0.1 uF,25V,20%,Y5V,0603,SMD   Elecraft part;  E530222. Digikey    
490-1575-2-ND
Anything close is fine (and probably fine without it).
Keith WE6R

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]