Hi,
So I had some success in fixing this and thought I would write it up here briefly for future reference. Short version C6 on the K3REF module had become a 12 ohm resistor. Longer version Finding the 7T line only going to 3.5 volts or so was suspicious. Measuring the resistance to ground of that line showed about 20 ohms where the 7 volts is generated at U11 on the RF board, very suspicious. The first step then was to remove any removable item that has a connection to the 7T line. That's most modules in the K3. Checking the resistance of the 7T line each time I removed a plug in module showed the fault to be somewhere on the K3REF module. The 7T line on this board goes to Q3 via R16, R8 and R9 and also to Q2 and U3 via L5. Measuring either side of L5 showed lower resistance on the Q2 and U3 side, now around 12 ohms as opposed to 14 or so at pin 3 of P75. Focus then was directed at Q2 and U3 as likely culprits being active devices likely more prone to failure but removing Q2 showed no change nor did very carefully lifting pin8 of U3 and confirming no connection to L5. That left C6 as the remaining component on that line and its removal restored a much healthier 2.7k resistance to ground on that line as formed by R16, R8 and R9 around Q3 noted above. I don't have any of the microscopic 0.1uF capacitors used in this location, are they 0402? but I have a good selection of 1206 parts and being smaller than the chokes on this board I considered it a suitable change. The board mounts very close to the chassis so size is critical. All restored and the rig is back to normal working order. I don't know if these capacitors are prone generally to such failures but at least it was on a plug in board so easy to narrow down. So that was a fun Saturday afternoon for an hour or so, hopefully the radio will keep on working well now. Martin, HS0ZED ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[hidden email] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [hidden email] |
Administrator
|
Hi all;
Very good troubleshooting Martin. That is not a common failure and those BYPASS caps are used everywhere. 0.1 uF,25V,20%,Y5V,0603,SMD Elecraft part; E530222. Digikey 490-1575-2-ND Anything close is fine (and probably fine without it). Keith WE6R ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[hidden email] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [hidden email] |
Free forum by Nabble | Edit this page |