In the last few days I have had the following problem, which cures
itself after the K3 has been on for 10-15 minutes. I am talking about TX
Data mode. For my normal operation, LIN OUT is set at 08 to 10.
*This is the problem: *The receiver and transmitter section appear to
behave normally, signals are received properly, and the gain controls
work properly, but there is no audio on the Lin Out. Using Config -> Lin
Out and resetting the level with VFO A has no effect.
Examining the Lin Out output line via FFT (e.g. as in SpectraVue or
FLDIGI) shows noise at the right level for the first 200-300 Hz from 0,
but a rapid drop-off (to more negative values) of 25-30 dB for the rest
of the passband. This is independent of "BAND." Normally, with the
settings I use, the noise in the first 200-30 Hz is ~ -85 dB on
SpectraVue's scale, with the passband noise around -65 dB. LO is at 0,
HI at 2.95, FC at 1.50, using F1.
The K3 is a K3/100-F Ser. No. 4103, running MCU 04.25, FPF 01.14, DSP1
02.71. It has the ATU and the KXV3A (factory) installed.
John Ragle -- W1ZI
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
