Tom,
The PA voltage connector pin problem will normally result in an ERR 12V
message.
It sounds like something has just gotten "mixed up".
Do you have a saved configuration file for that K3? If so, you may want
to try doing a Reset to Factory Defaults (EEINIT)and then restore the
configuration file from K3 Utility. If you do not have a saved
configuration file, you will have to install all the options manually
and go through the calibration procedures.
73,
Don W3FPR
On 10/10/2018 7:32 AM, Tom Lizak wrote:
> Hi Gang,
>
>
>
> Was doing the New England WX Net this AM on 75m and all of a sudden, NO
> OUTPUT...hmmm!
>
>
>
> I put it into PA By-pass and still nothing. I can hear the tone in another
> RX whether on PA or by-pass but NADA on the watt meter.
>
>
>
> Before I send it to the "Mother Ship", I was wondering if this could be the
> infamous PA connector pin issues ? PA temp @ 25C which is ambient temp of
> the room ATM.
>
> K3 s/n 00184.
>
>
>
> HELP !
>
> 73
>
> Tom/K1TL...
>
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html> Message delivered to
[hidden email]
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]