I just updated my firmware after being off the air for a long time. I used to save two frequencies in a memory...like 20m QRP and I would put CW in VFO A and SSB in VFOB.
For some reason, when I load a memory now, it does not update VFO B. When I read the memories from the K3 using the memory management software, it shows the correct VFO B frequency and mode. However, if I save a new memory on the K3 and read it with the software, VFO B is set to the same settings as VFO B.
Did this functionality quietly get stripped to scavenge more memory for other functions?
Jim W6VAR
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
