Hi,
I just updated my K3 (sn#3082) to the (MCU 5.38, FPF 1.25, DSP1
2.86) and performed the required TX Gain Calibration. The 5W
calibration matched the Bird wattmeter on each band, but the 50W
was over 50W on each band.
I wanted to calibrate the K3 wattmeter so I could repeat the
process, however, when holding the CONFIG button, then seeking
WMTR, it never appears. I see VFO OFS then XV1 ON, and no WMTR in
between.
Suggestions??
Thanks - Bill N4LG
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]