Gary, KA1J, wrote:
"Any other suggestions regarding a
heads up perhaps regarding
specialty assembly/test equipment I will need to
be ready for the k3
100W kit? "
The most helpful tool for
me was a nice tweezers
to pick up all those
little lockwashers. As far as
test equipment goes, a
standard DMM is helpful.
All the calibration and
alignement is either done at
the factory or performed
by initiating pre-programmed
routines in the
K3 itself. I especially appreciate
the
dial calibration
procedure, using WWV as a reference
to get the reading within
1-2 Hz. It's so easy, I check
it from time to
time.
Have
fun!
73 de Chuck
NI0C
K3/100
s/1061
K2/10 s/n
5853
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
