Hi,
I was playing around with fldigi and flrig to get rig control working with
my K3 on my 64-bit Ubuntu laptop (it was working fine before with the
32-bit laptop). I got it to work in the end (using Hamlib, the other
options wouldn't work), but somewhere along the way something must have
gone wrong in the K3 which I only noticed later.
For some reason in SSB mode, either LSB or USB, and on all bands, there is
no audio output at all on the headphones and speaker. I am not sure if
there is output on Line Out, but I think there might be although I can't
remember for sure.
The S-meter and all controls function as normally. If I switch to DATA
mode, I get the normal output FB, so I know the signal is being received as
it should. Also there is nothing wrong in CW mode.
After googling this I found an old thread somewhere, where somebody had had
a similar problem, but resolved it by restoring a configuration backup to
his K3. Well, I could do that but the backup I have is quite old and I am
not sure what I might have changed since then, in any case before I try
that I would like to ask here if there is a solution to this problem!
73, Thomas M0TRN
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
