20 posts
|
When P3 is turned off, I start the K3 Utility, and I will see my text decode data (both CW and PSK) in the VFO B window, and in the K3 Utility Terminal window. However, when the P3 is turned on, the data is still shown in the VFO B window, but does not show up on the K3 Utility Terminal screen.
K3: 4.112
P3: 00.36
I thought I read something about this on the reflector recently, but I've been searching and can't find it. I don't remember if this was a firmware glitch to be fixed, or ...?
Thanks gang!
Oscar, WB5GCX
|