Hi
Yes it is possible but not if you are not actually programming via rs232.
You have to issue a SWR command (or Swh I'm working from memory here) Cohen read the vfoa display with a Ds command and then issue the appropriate up and down commands. Same for vfob.
If you have no way to read the DS value and do some programming logic you are out of luck.
Hope this helps
73s Tom
-------- Original message --------
From: Charles Sanders <
[hidden email]>
Date: 27/05/2014 22:29 (GMT-05:00)
To:
[hidden email]
Subject: [Elecraft] K3 Noise Reduction Adjustment via CAT
Is it possible to adjust the K3 noise reduction level via CAT? I could not
find reference to it in the Programmer's Manual.
Any information on when/where that might be available would be appreciated.
73/Chuck/NO5W
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
