I have recently moved QTH and am now setting up my Elecraft radios in the new
shack - in exactly the same configuration as at the previous QTH. No
hardware changes, no firmware upgrades, same cable set.
Everything is working fine with the K3/P3/KPA500/KAT500 combination, with
one exception:
The signals displayed on the P3 rarely exceed S1 on the scale even when the
K3 S meter shows S9+.
I have replaced the BNC - BNC cable connecting the K3 IF out with the P3
input. No change in signal level.
Is there a simple way to check the K3 IF output for correct operation so
that I can home in on whether the issue is at the K3 or P3 end of the
connection?
Any pointers much appreciated!
73 David G3WGN M6O WJ6O
--
Sent from:
http://elecraft.365791.n2.nabble.com/______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
